Re: kannel 1.2.0 and SMPP v3.3

Maybe, however lots of SMSCs use TON/NPIs which have no correlation to the
source number format you are using (BT Cellnet/O2 being one of them). In
this case the TON/NPI is manually overloaded (hence why I added the code to
do that) and the source address can be what ever they tell you it should be.

In normal operation the TOP/NPI are calculated AUTOMATICALLY based on the
source address you set. Therefore unless the automatic code is wrong, or you
aren't manually forcing you're TON/NPIs where you need to, then the Source
Address is wrong.

Alex

----- Original Message -----
From: "Kaido Karner" <[email protected]>
To: <[email protected]>
Sent: Wednesday, July 24, 2002 12:57 PM
Subject: RE: kannel 1.2.0 and SMPP v3.3


> > If you haven't fixed this the Invalid source address means you
> > need to make sure your from= parameter is correct. If your source TON
was
> > wrong you would get a 0x00000048 or if your source NPI was wrong you
would
> get a
> > 0x00000049
>
> it's not so .. TON and NPI can be 'correct' by itself, but contradict the
> number format .. if this is a case You get an error about wrong source
> address ..
>
> k
>