RE: Siemens TC35 and AT+CMGF
"Oded Arbel" <[email protected]>
| Newsgroups | gmane.comp.mobile.kannel.devel |
|---|---|
| Message-ID | <[email protected]> |
> -----Original Message----- > From: Paul Keogh [mailto:[email protected]] > I am using a Siemens TC35 (firmware v2.01). > > The AT+CMGF=0 command always fails which causes the at2_init_device() > function to fail and hence the modem does not start. > > I think it would be better to check if this command is supported by > doing a AT+CMGF=? first. Does anyone else have this problem ? I don't remember it ever being discuessed and I know that some people do youse the TC35. setting CMGF is very important for Kannel, otherwise we cant send PDUs to the modem, so failing if CMGF=0 fails is correct, IMO. -- Oded Arbel m-Wise mobile solutions [email protected] +972-9-9581711 (116) +972-67-340014 ::.. Seen it all, done it all, can't remember most of it.