RE: GSM Signal Quality
"Oded Arbel" <[email protected]>
| Newsgroups | gmane.comp.mobile.kannel.devel |
|---|---|
| Message-ID | <[email protected]> |
The AT2 module can be configured to use the +CSQ command as a keep-alive command, and so its result would be written to the logs. but that result will never be used. it may be nice to add a feature to read and understand +CSQ return codes, but keep in mind that not all cellular modems support that command. -- Oded Arbel m-Wise mobile solutions [email protected] +972-9-9581711 (116) +972-67-340014 ::.. "My ambition is handicapped by laziness." -- Bukowskis Alter Ego Henry Chinaski in "Factotum" -----Original Message----- From: Rejected Mails Sent: Wednesday, October 16, 2002 11:22 AM To: Oded Arbel Subject: FW: GSM Signal Quality -----Original Message----- From: [email protected] on behalf of Stipe Tolj Sent: ג 15/10/2002 11:03 To: Andrea Viscovich Cc: [email protected] Subject: Re: GSM Signal Quality > Andrea Viscovich wrote: > > Sometimes it may happens that there is no signal for gsm modems. > As there is an AT+CSQ avalaible, > what do you think about doing an +CSQ every n minutes > to write in the log that there is no signal? a no signal state may cause to halt the sending process until the signal is back up again?! Just my two cents. Stipe [email protected] ------------------------------------------------------------------- Wapme Systems AG Vogelsanger Weg 80 40470 Düsseldorf Tel: +49-211-74845-0 Fax: +49-211-74845-299 E-Mail: [email protected] Internet: http://www.wapme-systems.de ------------------------------------------------------------------- wapme.net - wherever you are