Re: wap push to siemens again
Aarno Syvänen <[email protected]>
| Newsgroups | gmane.comp.mobile.kannel.devel |
|---|---|
| Message-ID | <[email protected]> |
UDH (both ports and SAR) are defined in WAP-259 (WDP Spec). Port numbers are capitulated in appendix 4 (A.4). SI spec is WAP-167 (contains an example tokenized SI document). Usually only Content-type is required here (actually WAP-145 states that only it is mandatory). What kind of Siemens phone did you use ? And a very stupid question: does it support WAP 1.2 ? Aarno On Friday, November 22, 2002, at 02:11 AM, Szymon Stasik wrote: > and which wap spec should I look into? I guess there is something > wrong in UDH... > > Stipe Tolj wrote: >>> I'd like to investigate the problem deeper and my question is if >>> there >>> is any possibility to have some push message correctly recognised on >>> siemens phone? I can look into wapforum specs, however any working >>> case >>> or some other tips would be helpfull. >> unfortunatly we at Wapme don't have these phones here, otherwise I may >> test too. Anyone that could provide more debugging here?! >> Stipe >> [email protected] >> ------------------------------------------------------------------- >> Wapme Systems AG >> Vogelsanger Weg 80 >> 40470 Düsseldorf >> Tel: +49-211-74845-0 >> Fax: +49-211-74845-299 >> E-Mail: [email protected] >> Internet: http://www.wapme-systems.de >> ------------------------------------------------------------------- >> wapme.net - wherever you are > > >