Re: PPG: wap-push-user specific smsc-id config

On Montag, Februar 3, 2003, at 12:52  Uhr, Stipe Tolj wrote:

> Hi list, Hi Aarno,
>
> I'm wondering how we can do something like this: (has been discussed
> already)
>
>   ...
>   group = ppg
>   ...
>   default-smsc-id = <foo>  # the default smsc-id to use in bearerbox
>
> this is pretty easy, but what about this:
>
>   ...
>   grou = wap-push-user
>   ...
>   smsc-id = <foo> # user specific smsc-id to use
>
> this is harder.
>
> I don't see any easy way in passing the smsc-id config value of a
> specific wap-push-user, let's say from
> gateway/wap_push_ppg.c:655:pap_request_thread() up to
> gateway/wapbox.c:334:pack_sms_datagram() where the sms splits are send
> to the bearerbox.

I think both variants make sense. I would actually recommend the 
following approach:

a) if &smsc=... is set on the push, use it otherwhise use the one 
defined in group=ppg
b) if group wap-push user has a default-smsc-id, use it if &smsc=.. is 
not set by step a)
c) if group wap-push user has a smsc-id, discard any already set 
smsc-id and force it to the value of the config file.


Andreas Fink
Global Networks Switzerland AG

------------------------------------------------------------------
Tel: +41-61-6666333  Fax: +41-61-6666334   Mobile: +41-79-2457333
Global Networks, Inc. Clarastrasse 3, 4058 Basel, Switzerland
Web: http://www.global-networks.ch/      [email protected]
------------------------------------------------------------------
Member of the GSM Association