Re: Fw: smsc messages

Is there anyway to make kannel retry sending after a failed message.. ? 
  ----- Original Message ----- 
  From: Andreas Fink 
  To: Patrick Mignott 
  Cc: [email protected] 
  Sent: Thursday, April 10, 2003 6:40 AM
  Subject: Re: Fw: smsc messages



  On Donnerstag, April 10, 2003, at 05:35 Uhr, Patrick Mignott wrote:


    hello. I am connected to a CMG SMPP 3.3 service for the last 5 week
    everything was ok, however I started to see about 10% FAIL sent message.
    (incoming is ok) now it's about 70% fail. I am not sure what the problem is
    but I suspect it's with CMG...please see the error messages below.. my
    volumes are very low.. what could it be ?

    3 error messages!


    \\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\
    2003-04-09 17:12:19 [7] ERROR: SMPP[INFOSERVICE]: SMSC returned error code
    0x00000058 in response to submit_sm.


  ESME_RTHROTTLED 0x00000058 Throttling error (ESME has exceeded
  allowed message limits)



    \\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\
    2003-04-09 17:19:19 [7] ERROR: SMPP[INFOSERVICE]: SMSC returned error code
    0x00000014 in response to submit_sm.


  ESME_RMSGQFUL 0x00000014 Message Queue Full



    \\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\
    2003-04-09 17:19:19 [7] ERROR: SMPP[INFOSERVICE]: SMSC returned error code
    0x000000FF in response to submit_sm.
    //////////////////////////////////


  ESME_RUNKNOWNERR 0x000000FF Unknown Error


  I think your SMSC is configured for very slow speeds or similar.

  Andreas Fink
  Global Networks Switzerland AG

  ------------------------------------------------------------------
  Tel: +41-61-6666333 Fax: +41-61-6666334 Mobile: +41-79-2457333
  Global Networks, Inc. Clarastrasse 3, 4058 Basel, Switzerland
  Web: http://www.global-networks.ch/  [email protected]
  ------------------------------------------------------------------
  Send SMS to +979 979 UNICEF (+979979864233) to donate a
  small amount to the children of Iraq. http://www.gni.ch/unicef