Re: Splitting makes problem

Hi Arne,

I am using SMPP smsc. Where can we set the TTL parameter you have told.
To which value should it be set?
When some part is failing, the error message is coming as:
"SMSC returned error code 0x00000009 in response to submit_sm."
Is this the same one you have got?

Thank you
Shanavaz.

  ----- Original Message ----- 
  From: Arne K. Haaje 
  To: [email protected] 
  Sent: Saturday, April 12, 2003 8:45 PM
  Subject: Re: Splitting makes problem


  Shanavaz E A wrote:
  > Hi,
  > When I send picture messages and logos, kannel is splitting it into 2 
  > or 3 parts.
  > But this splitting causes sending to fail. When I manually split and send
  > them by making a delay(say 100ms) between sending each part, there is
  > no problem of failure. Is there any way to avoid this. This manual splitting
  > and delaying causes some other problems to me.
  > Is there any way to insert some delay between individual parts of messages
  > in kannel itself? Or any way to avoid failure without delay itself?
  > Can any one help ?

  I had a similar problem with a CIMD2 SMSC. I had set the Time To Live to 
  -1. This caused the SMSC to fail the second message because the mobile 
  phone was busy receiving the first. Setting the TTL to a fixed value 
  solved the problem.

  -- 
  Med vennlig hilsen,
  Eurobate ASA

  Arne K. Haaje
  Senior Network Engineer
  --------------------------------------------------------------------
       Eurobate ASA - Postboks 4589 Nydalen - 0404 Oslo - Norway
  Phone: +47 23 22 73 73 - Fax: +47 23 22 73 74 - Mob: +47 92 88 44 66
                       http://www.eurobate.com/