Re: It's possible to send Push SI message through Virtual SMSC?
Aarno Syvänen <[email protected]>
| Newsgroups | gmane.comp.mobile.kannel.devel |
|---|---|
| Message-ID | <[email protected]> |
Hm. I think at2 modem should set alt-dcs, not ppg. And if there is only some quirky modems demanding it, it should be located in modems.conf. Aarno On Sunday, June 8, 2003, at 02:10 PM, Stipe Tolj wrote: > Mauricio Ramos wrote: >> >> Hi Folks, >> >> I would like to use a GSM phone as a Virtual SMSC (AT2) to send WAP >> Push SI/SL messages to another GSM phone. >> >> Is it possible? How? > > yes, should be possible. Some GSM modems require to have alt-dcs set > when sending binary SMS. > > I guess this can't be handled currently by Kannel's PPG, because it > sets the normal DCS value. > > Aarno, any idea from your side here? > > Stipe > > [email protected] > ------------------------------------------------------------------- > Wapme Systems AG > > Vogelsanger Weg 80 > 40470 Düsseldorf > > Tel: +49-211-74845-0 > Fax: +49-211-74845-299 > > E-Mail: [email protected] > Internet: http://www.wapme-systems.de > ------------------------------------------------------------------- > wapme.net - wherever you are >