RE: AT2 with Nokia 6210 memory problem

What is the optimal setting in terms of CNMI for a Nokai 6210 phone for
Kannel?

Kind regards,


Edwin Poot

-----Original Message-----
From: [email protected] [mailto:[email protected]] On Behalf
Of Edwin R. Poot
Sent: dinsdag 24 juni 2003 18:34
To: 'Oded Arbel'; [email protected]
Subject: RE: AT2 with Nokia 6210 memory problem


The strangest thing is that if I look in the phone memory, there are no
messages found. So they are routed to Kannel as expected. But still the
phone shows a dialog with "no new space for new messages" where I have
to select Ok to get rid of it. But the SMS-c is not delivering messages
anymore from that time on. Delivery reports are set to no. What is the
correct setting for CNMI? I use CNMI=2,2,0,0,0 and I have tried
CNMI=1,2,0,0,0.

It looks like the phone thinks it holds the messages, but they are not.

I am really puzzled. 

The problem is I have Orange as a customer but they only are supporting
the GSM 1800 frequency and the Wavecoms I normally use WMD02 only
support 900. (AT+CGMM response is 900P)

Hope someone knows a solutions to this.

Kind regards,


Edwin Poot

-----Original Message-----
From: Oded Arbel [mailto:[email protected]] 
Sent: dinsdag 24 juni 2003 19:23
To: Edwin R. Poot; [email protected]
Subject: RE: AT2 with Nokia 6210 memory problem


Are messages being stored in the SIM memory at all ? how about delivery
reports ? if not - what fills up the memory of the phone ?

--
Oded Arbel
m-Wise mobile solutions
[email protected]
 
+972-9-9581711 (116)
+972-67-340014
 
::..
Cinemuck, n.:
  The combination of popcorn, soda, and melted chocolate which covers
the floors of movie theaters.
	-- "Sniglets" / Rich Hall

> -----Original Message-----
> From: Edwin R. Poot [mailto:[email protected]]
> Sent: Tuesday, June 24, 2003 4:12 PM
> To: [email protected]
> Subject: AT2 with Nokia 6210 memory problem
> 
> 
> Hello,
> 
> I run into problemns with one of my modems, the Nokia 6210 phone. This

> phone is connected to Kannel and although I have configured kannel
> with using the phone memory instead of SIM memory () I keep
> getting a dialog
> on the phone, saying memory is full. As a result, the operator SMS-c
> does not deliver any more incoming SMS-es. The only thing 
> that helps is
> turning the phone off and on and restarting kannel. Only then messages
> are delivered again from the SMS-c to the phone.
> 
> Does anyone know a solution for this, I never ran into such problems
> with my Wavecom modems.
> 
> Thanks in advance for the help,
> 
> 
> Edwin Poot
> 
> 
> -----Original Message-----
> From: [email protected] [mailto:[email protected]] On Behalf

> Of Himalay Gopu
> Sent: dinsdag 24 juni 2003 14:40
> To: Stipe Tolj
> Cc: [email protected]
> Subject: RE: Kannel Routing and Performance Issues !
> 
> 
> I have used forced-smsc in sendsms-user and set denied-sms-id in smsc
> group --- is this not enough is it mandatory to set allowed-smsc-id
> 
> One more query
> 
> I have 4 smsc links with same smscid and if one drops dead then if had

> restart the smsc what would happen --- will kannel restart all the
> smsc links with that smscid
> 
> Himalay
> 
> 
> 
> 
> -----Original Message-----
> From: [email protected] [mailto:[email protected]]On Behalf 
> Of Stipe Tolj
> Sent: Tuesday, June 24, 2003 5:38 PM
> To: Himalay Gopu
> Cc: [email protected]
> Subject: Re: Kannel Routing and Performance Issues !
> 
> 
> Himalay Gopu wrote:
> > 
> > list
> > 
> > I have been using kannel for almost 2 months now but i have been 
> > facing few problems
> > 
> > Iam using kannel stable version on SuSe 8.1
> > 
> > Approach
> > I am connected to 4 smsc ( 2 smpp and 2 UCP )
> > 
> > Two of smsc connections are through VPN
> > 
> > Kannel is binding to 6 servers for receiving SMS and one to
> send SMS
> > for one SMPP SMSC --- I have 7 smsc connections with same smsc-id 
> > ----Is this rite approach
> > 
> > Anything going wrong in my approach
> > Issues
> > 
> > 1) I have seen that most of my messages are routed through a 
> > particular smsc even after i set the CGI variable  smsc
> 
> have you 'allowed-smsc-id' directives in the smsc groups?!
> 
> If no, then Kannel will simply pick the first one that is considered
> online.
> 
> > 2) I have not crossed 30 sms for min throughput ( does VPN
> got to do
> > anything with throughput of Kannel )
> 
> I don't think so. I guess your internet connection itself is not the
> limiting factor. I guess it's more to the SMSC provider itself.
> 
> The fastes we got was 55 msg/sec. to O2 (Germany). All others are
> performing less. So it's not a limitation of Kannel. Kannel can deal 
> with a *lot* more.
> 
> > How can make Kannel more robust ----can anyone tickle their
> brains and
> 
> > throw some tips
> 
> First of all, if you use 1.2.1 stable, you may consider upgrading to
> current cvs tree, which is almost 1.3.2-pre (hence 1.3.2 will be 
> released shortly).
> 
> We have cvs tree running on our production servers with 307 links in 3

> instances, performing very reliable.
> 
> Stipe
> 
> [email protected]
> -------------------------------------------------------------------
> Wapme Systems AG
> 
> Vogelsanger Weg 80
> 40470 Düsseldorf
> 
> Tel: +49-211-74845-0
> Fax: +49-211-74845-299
> 
> E-Mail: [email protected]
> Internet: http://www.wapme-systems.de
> -------------------------------------------------------------------
> wapme.net - wherever you are
> 
> 
>