Re: [RFC] changing defaults of SMPP TON and NPI for MT?

On Dienstag, Juni 24, 2003, at 09:41  Uhr, Nisan Bloch wrote:

> At 07:22 PM 6/24/03 +0200, Andreas Fink wrote:
>
> -1 from me. + is there to indicate international.
> No reason to put the default to international as then there is no way 
> to indicate national again.
> (you can not specifically put a "missing" + into the URL)
>
>
>
> surely then with a + the smpp code will autodetect and set to 
> international which is what you want. Numbers without a + could be 
> either national or international. Its only the default we want to 
> change.

no. you can not change it to national if the default is international.


if you use autodetect it will always be international with or without +
if you hardcode it to be national, then you can not set it to 
international neither.
So whatever you do, all numbers will be either international or 
national being sent to the SMSC.
The current behaviour allows you to send international numbers as 
international and national ones as national.

To have the default be international, there's a config parameter to 
hardcode it to international.
So this  way around its solved by config. The other way around, there's 
no way to do it in config at all
>
Andreas Fink
Global Networks Switzerland AG

------------------------------------------------------------------
Tel: +41-61-6666333  Fax: +41-61-6666334   Mobile: +41-79-2457333
Global Networks, Inc. Clarastrasse 3, 4058 Basel, Switzerland
Web: http://www.global-networks.ch/      [email protected]
------------------------------------------------------------------