Re: Bind TON / NPI

Hi,

I am trying to configure Optus link here in australia, and optus have 
specified
values for Bind NPI and TON which are different from default.

The log details of interest are:

2004-09-22 13:23:50 [2619] [8] DEBUG: SMPP PDU 0x8196c78 dump:
2004-09-22 13:23:50 [2619] [8] DEBUG:   type_name: bind_receiver
2004-09-22 13:23:50 [2619] [8] DEBUG:   command_id: 1 = 0x00000001
2004-09-22 13:23:50 [2619] [8] DEBUG:   command_status: 0 = 0x00000000
2004-09-22 13:23:50 [2619] [8] DEBUG:   sequence_number: 2 = 0x00000002
2004-09-22 13:23:50 [2619] [8] DEBUG:   system_id: "xxxxxxxx"
2004-09-22 13:23:50 [2619] [8] DEBUG:   password: "xxxxxxxx"
2004-09-22 13:23:50 [2619] [8] DEBUG:   system_type: "smpp"
2004-09-22 13:23:50 [2619] [8] DEBUG:   interface_version: 52 = 0x00000034
2004-09-22 13:23:50 [2619] [8] DEBUG:   addr_ton: 0 = 0x00000000
2004-09-22 13:23:50 [2619] [8] DEBUG:   addr_npi: 0 = 0x00000000
2004-09-22 13:23:50 [2619] [8] DEBUG:   address_range: NULL


Notice the:
        2004-09-22 13:23:50 [2619] [8] DEBUG:   addr_ton: 0 = 0x00000000
        2004-09-22 13:23:50 [2619] [8] DEBUG:   addr_npi: 0 = 0x00000000

But optus specifies the following:

        Bind TON:       0
        Bind NPI:       4

How can I configure this in kannel 1.3.2, or is it not possible.

Thanks
Jason