Re: Multiple smsc and exec script replies

Sergey Saukh wrote:

> Hi,
> 
> I have Kannel 1.3.2 version installed. It works fine, but I've encountered a 
> one problem:
> 
> I have 2 smsc definitions (listed below) and some services set up for use with 
> those smsc. When sms arrives, kannel looks from what smsc and for what msisdn 
> it was and passes it to corresponding sms-service. And I assume that reply 
> from this service _must_ go through the same smsc from which sms was 
> received. But sometimes it tries to send reply through other smsc and it 
> fails, because there are different OA for each smsc. 
> 
> Is there any way to explicitly define an smsc in sms-service group through 
> which replies will be send? Or may be there is other solution?

yes, as smsbox does the sms-service and responds with the same smsc-id to 
bearerbox for the reply MT message, you will have to use 'allowed-smsc-id' 
inside the smsc group to have the message only transported via the originated 
link, ie.

> Here is smsc part of my config:
> 
> group = smsc
> smsc = smpp
> smsc-id = smsc_lich
> host = xx.xx.xx.xx
> port = 3400
> receive-port = 3400
> smsc-username = xxx
> smsc-password = xxx
> system-type = VMA
> source-addr-ton = 0
> source-addr-npi = 1
> dest-addr-ton = 1
> dest-addr-npi = 1
allowed-smsc-id = "smsc_lich"

> 
> group=smsc
> smsc=smpp
> smsc-id=smsc_anton
> host = xx.xx.xx.xx
> port= 3400
> receive-port = 3400
> smsc-username = yyy
> smsc-password = yyy
> system-type = "VMA"
> source-addr-ton=0
> source-addr-npi=1
> dest-addr-ton=1
> dest-addr-npi=1
allowed-smsc-id = "smsc_anton"

Stipe

mailto:stolj_{at}_wapme.de
-------------------------------------------------------------------
Wapme Systems AG

Vogelsanger Weg 80
40470 Düsseldorf, NRW, Germany

phone: +49.211.74845.0
fax: +49.211.74845.299

mailto:info_{at}_wapme-systems.de
http://www.wapme-systems.de/
-------------------------------------------------------------------