Re: Not getting DLR status=1

exactly. another option would be that you misconfigured the type of  
SMS-message-id they supply. This only applies on SMPP. In that case  
you however would get no reports at all.

On 01.11.2006, at 09:29, migital wrote:

>
> Does this mean, that there is no problem with kannel's code which i  
> am using,
> but the problem is from the SMSC's end. They are not providing us  
> with the
> correct reports.
>
> Thanks
>
>
>
> Andreas Fink-3 wrote:
>>
>> I think the answer to this is dependent on the SMSC.
>> All  SMSC drivers support successful delivery message. so if the SMSC
>> doesn't send it to you, its not a real smsc but some freaky
>> aggreggator who doesn't give you proper reports.
>>
>> On 01.11.2006, at 07:32, migital wrote:
>>
>>>
>>> Hi All,
>>>
>>> I am setting dlr-mask=31, but i never get "delivery success" as a
>>> status
>>> back from the SMSC, the only delivery description which  am  
>>> getting is
>>> "message buffered.  smsc submit", though the sms messages gets
>>> successfully
>>> delivered to mobile phones.
>>>
>>> I also tried setting the value of "dlr-mask=3" but then i did not
>>> get any
>>> delivery status back from the SMSC. When I set the value of "dlr-
>>> mask=15"
>>> then again i got  "message buffered.  smsc submit" back from the  
>>> SMSC.
>>>
>>> Can any body please suggest me what the problem is, is the problem
>>> is at
>>> SMSC's end or it is from my end.
>>>
>>> Any help will be highly appreciated.
>>>
>>> Thanks
>>>
>>>
>>> -- 
>>> View this message in context: http://www.nabble.com/Not-getting-DLR-
>>> status%3D1-tf2550493.html#a7108806
>>> Sent from the Kannel - Dev mailing list archive at Nabble.com.
>>>
>>
>>
>>
>>
>
> -- 
> View this message in context: http://www.nabble.com/Not-getting-DLR- 
> status%3D1-tf2550493.html#a7109709
> Sent from the Kannel - Dev mailing list archive at Nabble.com.
>