Re: AT command for dialling

This is not so trivial. Basically it would need a "special type" of  
SMS to be send down the pipe of smsbox to bearerbox to end up on the  
AT driver to do some special dial command on this. Another option  
would be to add it to the administrative interface of bearerbox (like  
shutdown and startup of drivers/ smsc conncetions) to be handed over  
to the AT driver in charge. Thats probably much easier but means your  
application has to deal with two different http interfaces. It is  
possible to do but for sure not something standard kannel should have  
in my eyes because its a very specific hack for a very specific purpose.


On 03.12.2006, at 21:57, Teodor Robas wrote:

>
> Hello all,
>
> I have a (experimental) box installed with a SE T290 phone.
> I already placed command ATD123iG instead of the normal init string  
> in order to call to info credit number.
> Then network sends back a SMS (it worked).
>
> I enter into code trying to find a way to make kannel dial when a  
> http command is issued.
> But when I dive into code in smsc_at.c I found a bunch of functions  
> that I do not see from where are called. And I am shure that are  
> used (eg at2_open_device).
>
> It is possible for somebody to point me to a usefull spot of  
> documentation ?
> Or make a very short description of internal design of kannel ?
> Or, at least point me the next level on top of smsc at driver ?
>
> Best Regards,
> Teodor
>