Re: AT2 module on Mac OS X

On 30.07.2007, at 16:39, P. A. Bagyenda wrote:

> For some reason, the stock AT2 SMSC module does not quite work  
> right under OSX (bluetooth serial). After making the changes  
> (attached), largely by inspecting minicom's code, it works fine. No  
> time to figure out why, but perhaps somebody can take a look and  
> make sense of it.
>
> P.
>
> <smsc_at.diff>


This surprises me as I wrote that part under MacOS X...(however not  
as bluetooth serial).

Looking at your diff, I can't see much difference except the tios  
initialisation (which I copied over from AT1 module...) and that you  
clear O_NDELAY with a fcntl after the open (). (by the way, dont use C 
++ style in a  C programm like initializing a variable n in the  
middle of a block).

As this patch per se could break stuff on other platforms, it would  
be advisable to only change what's really needed. And so far I can't  
see what that would be.


Andreas Fink

Fink Consulting GmbH
Global Networks Schweiz AG
BebbiCell AG

---------------------------------------------------------------
Tel: +41-61-6666330 Fax: +41-61-6666331  Mobile: +41-79-2457333
Address: Clarastrasse 3, 4058 Basel, Switzerland
E-Mail:  [email protected]
www.finkconsulting.com www.global-networks.ch www.bebbicell.ch
---------------------------------------------------------------
ICQ: 8239353 MSN: [email protected] AIM: smsrelay Skype: andreasfink
Yahoo: finkconsulting SMS: +41792457333