Re: custom dlr mask

On 25.05.2008, at 19:31, sangprabv wrote:

> Hi,
> What I mean here is, currently Kannel support 1,2,4,8,16 as DLR value.
> My telco send back the DLR with 17 as the value which means  
> insufficient
> balance via HTTP SMSC (http://host:port/?dlr=17).

You are mixing up what kannel uses as dlrmask and what external  
suppliers use as dlrmask.
Those values are independent.

> I have patched smsc_http.c to grab this value. But since this value  
> is not a standard
> one for Kannel, then Kannel doesn't destroy this dlr mask.

Destroy? How you want to destroy a DLR mask? It's an integer used  
internally.


> What Im trying to do also is how to destroy this dlr mask. TIA.
>
> Regards,
>
>
> Willy
> On Sun, 2008-05-25 at 15:12 +0200, Andreas Fink wrote:
>> what you mean by "custom" dlr mask?
>>
>> DLR mask is a field which is internal to kannel. Its a bitfield. so
>> 0x17 would give you 0x10 + 0x4 + 0x2 + 0x1 type of messages back.
>> Depending on which bits are set, certain reports from the SMSC are
>> sent back or not. Some SMSC's dont support all of those. For example
>> SMPP doesnt have a message called "Buffered" like this is in EMI/UCP.
>>
>>
>>
>>
>> On 25.05.2008, at 10:33, sangprabv wrote:
>>
>>> Hi,
>>> I have a situation where I need to implement a custom dlr mask. I  
>>> have
>>> read dlr.h, and I found some definitions for each dlr mask.
>>> My question is if I need to implement let say 17 as a custom dlr  
>>> mask.
>>> Will it be:
>>> #define DLR_CUSTOM 0x17?
>>> And also how to make Kannel automatically destroy this custom dlr
>>> mask?
>>> TIA
>>>
>>> Regards,
>>>
>>>
>>> Willy
>>>
>>
> -- 
> [sangprabv]
> http://www.sangprabv.web.id