Re: development cycle
Andreas Fink <[email protected]>
| Newsgroups | gmane.comp.mobile.kannel.devel |
|---|---|
| Message-ID | <[email protected]> |
On 30.05.2008, at 14:27, Tony Kirkham wrote: > I am a bit new to this and would like to know the "best practices" > of repeated compiles as I attempt to make Kannel work with my modem > (works over IP and requires username and login). More specifically, > with each change to the code that I make that I want to test do I > need to go through the ./configure --prefix=/mytestspot/kannel -> > make -> sudo make install cycle, or are there better steps? > ./configure is only needed if you have changes in the environment. make will produce the files. You can run them from the places they are built for testing instead of the install directories. Kannel has only a few binaries, "bearerbox" and "smsbox" and for wap "wapbox". And to launch, you need a config file. So you can run it wherever you want to put it. Andreas Fink Fink Consulting GmbH Global Networks Schweiz AG BebbiCell AG IceCell ehf --------------------------------------------------------------- Tel: +41-61-6666330 Fax: +41-61-6666331 Mobile: +41-79-2457333 Address: Clarastrasse 3, 4058 Basel, Switzerland E-Mail: [email protected] www.finkconsulting.com www.global-networks.ch www.bebbicell.ch --------------------------------------------------------------- ICQ: 8239353 MSN: [email protected] AIM: smsrelay Skype: andreasfink Yahoo: finkconsulting SMS: +41792457333 http://a-fink.blogspot.com/ A developers view about iPhone SDK