Re: [PATCH] EMI_X25 smsc module support for high speed modems

Not exactly the same. In the default case you are supposed to set it to the 
actual bps requested, not to 9600. Could you update?

BR,
Nikos
----- Original Message ----- 
From: "Vincent CHAVANIS" <[email protected]>
To: <[email protected]>
Sent: Monday, February 16, 2009 12:31 PM
Subject: [PATCH] EMI_X25 smsc module support for high speed modems



Adapted paul's patch for EMI_X25 SMSC

Vincent.


P. A. Bagyenda a ΞΉcrit :
> Thanks.
>
>  On the issue of non-standard speeds, I've tested this on Mac OS X
> (which uses bps value as actual speed value) with a 460800 (i.e.
> non-standard) modem, and it works just fine. Said modem also works well
> under Linux. I believe no issue arises since it is the user
> responsibility to provide the correct speed -- and also buy a supported
> modem :)
>



--------------------------------------------------------------------------------


> diff -rauw /gateway-cvs/gw/smsc/smsc_emi_x25.c 
> /gateway/gw/smsc/smsc_emi_x25.c
> --- /gateway-cvs/gw/smsc/smsc_emi_x25.c 2009-01-14 10:24:05.000000000 
> +0100
> +++ /gateway/gw/smsc/smsc_emi_x25.c     2009-02-16 11:20:55.000000000 
> +0100
> @@ -496,7 +496,23 @@
>
>     /* The speed initialisation is pretty important. */
>     tcgetattr(fd, &tios);
> -#if defined(B115200)
> +
> +#if defined(B921600)
> +    cfsetospeed(&tios, B921600);
> +    cfsetispeed(&tios, B921600);
> +#elif defined(B576000)
> +    cfsetospeed(&tios, B576000);
> +    cfsetispeed(&tios, B576000);
> +#elif defined(B500000)
> +    cfsetospeed(&tios, B500000);
> +    cfsetispeed(&tios, B500000);
> +#elif defined(B460800)
> +    cfsetospeed(&tios, B460800);
> +    cfsetispeed(&tios, B460800);
> +#elif defined(B230400)
> +    cfsetospeed(&tios, B230400);
> +    cfsetispeed(&tios, B230400);
> +#elif defined(B115200)
>     cfsetospeed(&tios, B115200);
>     cfsetispeed(&tios, B115200);
> #elif defined(B76800)
> @@ -512,9 +528,14 @@
>     cfsetospeed(&tios, B19200);
>     cfsetispeed(&tios, B19200);
> #elif defined(B9600)
> + #if B9600 == 9600
> +    cfsetospeed(&tios, 9600);
> +    cfsetispeed(&tios, 9600);
> + #else
>     cfsetospeed(&tios, B9600);
>     cfsetispeed(&tios, B9600);
> #endif
> +#endif
>     kannel_cfmakeraw(&tios);
>     tios.c_cflag |= (HUPCL | CREAD | CRTSCTS);
>     ret = tcsetattr(fd, TCSANOW, &tios);
>