Re: Using smppbox id

In my case, there is an application between bearerbox and smppbox.
Thus application must route to smppbox and not to its clients.

Aarno


On 18.10.2011, at 23:25, Rene Kluwen wrote:

> In this case the boxcid represents the particular ESME in subject to route
> the DLR/MO back to.
> Every ESME represents a different box as far as bearerbox is concerned.
> Multiple clients mean multiple bearerbox connections.
> What is (in your opinion) the bug in this logic?
> 
> == Rene
> 
> -----Original Message-----
> From: Andreas Fink [mailto:[email protected]] 
> Sent: Tuesday, 18 October, 2011 17:47
> To: Rene Kluwen
> Cc: devel Devel
> Subject: Re: Using smppbox id
> 
> On 18.10.2011, at 17:44, Rene Kluwen wrote:
> 
>> Once you look further in the opensmppbox documentation, you will see that
>> system-type (or system-id if use-systemid-as-smsboxid is set to true) is
>> used as boxcid whilst communicating to bearerbox.
>> This is to facilitate the proper return path for DLR's (and also: MO's) to
>> the different ESME clients that are connected to opensmppbox.
>> 
>> Secondly: You are right that opensmppbox-id is useless for routing
> purposes.
>> That's why it is never used.
> 
> but the purpose of the box-id is the routing back to the proper box. That's
> why I believe this is  a bug
> if you want to carry along ESME system type information to the bearerbox for
> logging or whatever, that's fine but it shouldnt be in the box-id as that
> has a clear purpose.
> 
> 
> 
> 
> 
>