Re: Patch for more detailled modem use.

Hi Andreas

It looks fine. I tested with serial modem (enfora) and works fine.

However I wasn't able to test it with rawtcp connection since my
production service does not have an updated kannel and there I do have
that time of connection.

A question, how often does the signal info get updated? The rest is
mostly "fixed"until you disconnect/reconect a modem but not the signal
that can vary often. Maybe a config entry on the modem config to set
its refresh rate?

BTW, what about a feature that will allow us to send specific single
commands to the modem without stoping the connection to have access to
the modem com port?

Regards

Alvaro



On 6/21/12, Andreas Fink <[email protected]> wrote:
> Hi folks,
>
> I'm working on improving the AT driver again, the project which brought me
> to kannels 11 years ago (time goes fast)
>
> The attached patch does add a new status information to the status page
> which includes things like IMSI, Card ID, MSISDN (if available) etc.
> This is very useful if you use USB adapters which change their naming based
> on where they are plugged or when they are plugged or when you dont know
> which port name matches which physical port.
>
> So instead of seeing a line on http://localhost:1234t/status
>
>     port14[port14]    AT2[port14] (online 1s, rcvd: sms 0 (0.00,0.00,0.00) /
> dlr 0 (0.00,0.00,0.00), sent: sms 0 (0.00,0.00,0.00) / dlr 0
> (0.00,0.00,0.00), failed 0, queued 0 msgs)
>
>
> You will see something liek this:
>
>
>     port14[port14]    AT2[port14] (online 24s, rcvd: sms 0 (0.00,0.00,0.00)
> / dlr 0 (0.00,0.00,0.00), sent: sms 0 (0.00,0.00,0.00) / dlr 0
> (0.00,0.00,0.00), failed 0, queued 0 msgs)
>         CurrentOperator: 22802 Signal: 17 CardNumber: 89410212614001299889
> Device: /dev/cu.usbserial-001412FAC
>
>
> Before committing this it to SVN, I would like to have a few guys test this
> with other modem types (in my case I used Wavecom's) to see if its properly
> working there too.
>
>
>
>
>
> Also in my setup delivery reports don't work but i have not figured out why
> yet. Looks like the modems never give them back to me. Anybody seen this
> working in his setup?
>
>
> Andreas Fink
>
>


-- 
|-----------------------------------------------------------------------------------------------------------------|
Envíe y Reciba Datos y mensajes de Texto (SMS) hacia y desde cualquier
celular y Nextel
en el Perú, México y en mas de 180 paises. Use aplicaciones 2 vias via
SMS y GPRS online
              Visitenos en www.perusms.NET www.smsglobal.com.mx y
www.pravcom.com