RE: Error while SQLBOX running with MSSQL support

This might be a credential problem.

 

== Rene

 

From: [email protected] [mailto:[email protected]] On
Behalf Of manas mohanty
Sent: maandag 5 november 2012 8:32
To: [email protected]; [email protected]
Subject: Error while SQLBOX running with MSSQL support

 

Hi All,
I am trying to implement kannel cvs version and sqlbox cvs version with
mssql support.

I have installed freeTDS successfully.

configure kannel successfully with below command 
./configure --with-mssql=/usr/local --enable-localtime

the make and make installed

kanne runs successfully with MSSQL connectivity.

Then I configure sqlbox 

 

./configure --with-kannel-dir=/home/kannel --with-mssql=/usr/local

 

and success fully configured

 

Configuring Kannel and DB dependancies ...

checking for Ct-Lib support... no

checking for FreeTDS Ct-Lib support... yes

checking for dlopen... no

checking for dlopen in -ldl... yes

checking for gw-config... /home/kannel/gw-config

checking Kannel version... svn-r5011M

checking Kannel libs... -L/usr/local/lib/kannel -lgw -lwap -lgwlib -lrt
-lresolv -lnsl -lm  -lpthread -lxml2 -lz -lm -L/usr/local//lib -lct

checking Kannel includes... -I/usr/local/include/kannel -g -O2
-D_XOPEN_SOURCE=600 -D_BSD_SOURCE -D_LARGE_FILES= -I/usr/include/libxml2
-I/usr/local//include

checking for cfg_create in -lgwlib... yes

checking for Kannel's DB support... ok

 

Generating output files ...

configure: creating ./config.status

config.status: creating Makefile

config.status: creating gw/Makefile

config.status: creating rpm/sqlbox.spec

config.status: creating sb-config.h

config.status: sb-config.h is unchanged

config.status: executing depfiles commands

config.status: executing libtool commands

 

after success fully install sqlbox and configure mssql connectivity when I
start sqlbox following error showing frequently .

 

2012-11-05 12:52:52 [13398] [0] ERROR: ct_send() failed

 

2012-11-05 12:52:52 [13398] [0] ERROR: MSSQL: DB selection failed!

2012-11-05 12:52:52 [13398] [0] DEBUG: DBPool has too few connections,
reconnecting up to maximum... 

 

Please help me in this regards ..

 Thanks in advance

 

Regards,

Manas