Re: Kannel Multiple DB connection

Hi
In this case try to use a HA proxy as a load balancer  between kannel and
your db nodes, but in this case data is not the same in the tow nodes.

Regards
Saber


2014-06-03 10:23 GMT+01:00 Abdul Basit <[email protected]>:

> Hi, smii
>
> Thank you for prompt reply.
>
> This is one way. right!
>
> But my architecture is using two Mysql master nodes in parallel so i don't
> have one virtual IP or floating IP.
> Instead i have two DB IPs.
>
> Is there any way to open two DB connections on different IPs?
>
>
> --
> regards,
>
> abdul basit | p: +92 32 1416 4196 | o: +92 30 0841 1445
>
>
> On Tue, Jun 3, 2014 at 4:02 PM, smii saber <[email protected]> wrote:
>
>> Hi Abdul basit
>> Normally in the mysql-connection group you have to configure the  host
>> ip adresse of your mysql db, so:
>> 1- you install you db cluser system
>> 2- configure the virtual ip on the  host ip adresse of your mysql in
>> kannel configuration file
>>
>> group = mysql-connection
>> id = mydlr
>> host = "virtual ip adress of your db nodes"
>> username = foo
>> password = bar
>> database = dlr
>> max-connections = 1
>>
>>
>>
>> 2014-06-03 9:37 GMT+01:00 Abdul Basit <[email protected]>:
>>
>> Dear Team,
>>>
>>> I am using kannel for SMPP connectivity and storing DLR in mysql DB.
>>>
>>> Now working on a scalable solution using Mysql multi-master setup.
>>> Currently Kannel connect to only 1 DB server for DLR storage.
>>>
>>> Is there any way that i can configure kannel for multiple master DB
>>> servers (either in load balance mode or in failover manner)?
>>>
>>> Looking forward for suggestions.
>>>
>>> --
>>> regards,
>>>
>>> abdul basit | p: +92 32 1416 4196 | o: +92 30 0841 1445
>>>
>>
>>
>