RE: Throttling Error

No all time. Some times it stops sending for 1 seconds , sometimes not stops at all. Is there a way to set this interval to fixed value, 60 sec for example.

 

 

From: Andreas Fink [mailto:[email protected]] 
Sent: Thursday, July 03, 2014 2:47 PM
To: Алексей Мальгин
Cc: spameden; devel Devel
Subject: Re: Throttling Error

 

This is the expected behaviour. It will retry a few seconds later.

You can see in the log that after every throttling error you got, it stops sending for 2 seconds.

 

On 03 Jul 2014, at 09:44, Алексей Мальгин <[email protected]> wrote:





Thanks for the response!

 

> there is nothing to be done about this. Kannel does stop sending if it gets a throttling error and resumes a little bit later.

> This is part of the protocol and does not require any further config settings

 

But it has not stopped sending. It's just resends PDU later, but still sending new submit_sm for other messages. See attached log, please.

 

> Yup. Alexey, you should contact your SMSC operator and ask them to modify throttling limit for you to reflect your needs. (e.g. at least 10sms/second).

 

It’s test connection with new SMSC. It has limit 20 sms per minute in test mode.

 

 

From: spameden [ <mailto:[email protected]> mailto:[email protected]] 
Sent: Thursday, July 03, 2014 1:45 PM
To: Andreas Fink
Cc: Алексей Мальгин; devel Devel
Subject: Re: Throttling Error

 

 

 

2014-07-03 10:16 GMT+04:00 Andreas Fink < <mailto:[email protected]> [email protected]>:

there is nothing to be done about this. Kannel does stop sending if it gets a throttling error and resumes a little bit later.

This is part of the protocol and does not require any further config settings

 

Yup. Alexey, you should contact your SMSC operator and ask them to modify throttling limit for you to reflect your needs. (e.g. at least 10sms/second). 

 

On 03 Jul 2014, at 05:08, Алексей Мальгин < <mailto:[email protected]> [email protected]> wrote:

 

Hello,

 

We need help with processing  Throttling Error. SMSC requires us to wait 60 seconds and resend request. Can you help us to setup kannel well? Our config in attachment. Is it possible?

 

We use Kannel 1.5.0 with sqlbox, smpp 3.4.

<sqlbox.conf><kannel.conf>

 

 

<smsc.log>