RE: Throttling Error

I understand, but it’s required rule for passing the test with SMSC connection. When we will pass it, we will have this interval = 1 second.

 

 

From: Andreas Fink [mailto:[email protected]] 
Sent: Thursday, July 03, 2014 3:03 PM
To: Алексей Мальгин
Cc: [email protected]; devel Devel
Subject: Re: Throttling Error

 

FYI, the standard doesnt say how long you have to wait until you retry after getting a Throttled error.

It only says:

 

            Throttling error (ESME has exceeded allowed message limits). 

            This type of error is usually returned where an ESME has exceeded a predefined messaging rate restriction applied by the operator.

 

If you wait 60 seconds before retrying it will slow your sending down a hell of a lot.

Its totally ok to retry a couple of seconds later to see if we still exceed "allowed message limits".

 

There's nothing wrong with that. This is not an error. This is what it is meant to be.

 

 

On 03 Jul 2014, at 09:58, Алексей Мальгин <[email protected]> wrote:





Hi,

 

Thanks for the response!

 

It will resolve problem with resending interval, but how can I make kannel stop sending PDU for some time after this error? Not for this message, for all messages in queue.

 

From:  <mailto:[email protected]> [email protected] [ <mailto:[email protected]> mailto:[email protected]] 
Sent: Thursday, July 03, 2014 2:46 PM
To: Алексей Мальгин;  <mailto:[email protected]> [email protected]
Subject: RE: Throttling Error

 

Hello,

 

I think this can be configured with this release using parameters : sms-resend-freq and sms-resend-retry.

I give you an example : sms-resend-freq = 900 (15 mins) and sms-resend-retry = 10 : means that the retry will be done 10 times every 15 minutes after receiving the 0x0058 error code for throttling error.

 

Hope this could help you..

Regards,

 

De : devel [ <mailto:[email protected]> mailto:[email protected]] De la part de ??????? ???????
Envoyé : jeudi 3 juillet 2014 04:08
À :  <mailto:[email protected]> [email protected]
Objet : Throttling Error

 

Hello,

 

We need help with processing  Throttling Error. SMSC requires us to wait 60 seconds and resend request. Can you help us to setup kannel well? Our config in attachment. Is it possible?

 

We use Kannel 1.5.0 with sqlbox, smpp 3.4.