Re: receiving delivery issue

Hello,

I found this parameter in kannel registered_delivery, how do I use it in
the kannel.conf?

When I place it the bearbox wont run

Regards

On Sat, Jan 19, 2019 at 7:18 PM Web Min <[email protected]> wrote:

> Hello,
>
> I'm using the following configuration on my kannel on 3 gateways, each
> gateway contains 2 sessions, one for sending and the other for receiving,
> the below is for receiving delivery status.
>
> I have no issue with all of them till 3 months before one of them not able
> to pull the status, at the same time the same gateways is connected with
> more than 6000 clients with no issue at all.
>
> The provider asked me to change the register_dlr=1 , any help plz?
>
> interface-version = 34
> host = xx.xx.xx.xx
> port = 0
> receive-port = 8899
> smsc-username = user
> smsc-password = pass
> system-type = VMA
> source-addr-ton = 5
> source-addr-npi = 1
> dest-addr-ton = 0
> dest-addr-npi = 0
> keepalive = 600
> reconnect-delay = 3
> enquire-link-interval = 30
> esm-class = 0
> msg-id-type = 0x01
>