Re: Monit doesn't understand ssl or https

thanks for data. Your monit version doesn’t support these statements:

- the “set ssl” statement was added in monit 5.15.0

- the “protocol https” was added in monit 5.9.0 (it was necessary to use “protocol http type tcpssl” in older versions)



7. 7. 2019 v 17:31, Roland Giesler <[email protected]>:

> This is what I have:
> 
> :~# monit -V
> This is Monit version 5.6
> Copyright (C) 2001-2013 Tildeslash Ltd. All Rights Reserved.
> 
> Installed from Ubuntu 14.04 repositories.  (I just checked the Ubuntu version and realised it's actually still 14.04, so I'm upgrading it)
> 
> I report back when I'm done
> 
>> On Fri, Jul 5, 2019 at 8:53 PM [email protected] <[email protected]> wrote:
> 
>> Please can you check if monit was compiled with SSL? For example:
>> 
>> $ monit -V
>> This is Monit version 5.26.0
>> Built with ssl, with ipv6, with compression, with pam and with large files
>> Copyright (C) 2001-2019 Tildeslash Ltd. All Rights Reserved.
>> 
>> Best regards,
>> Martin
>> 
>> 
>>> On 5 Jul 2019, at 19:50, Roland Giesler <[email protected]> wrote:
>>> 
>>> I have monit installed on Ubuntu 18.04 (some nodes are reporting to M/Monit), but a few test nodes are not yet and I'm trying to figure out how to monitor https services.
>>> 
>>> Firstly I'm trying to set the ssl option in /etc/monit/monitrc with:
>>> 
>>>  set ssl options {
>>>      verify: disabled
>>>  }
>>> 
>>> However, when I start monit with 
>>> ~# service monit restart
>>> 
>>> I get this result:
>>> 
>>>  * Restarting daemon monitor monit    
>>> /etc/monit/monitrc:133: Error: syntax error 'ssl'
>>> 
>>> If I comment out the ssl configuration, I get an error at the first https reference.
>>> 
>>> The content:
>>> 
>>> check host FishEagle-Production with address 192.168.0.22
>>>     if failed host 192.168.0.22 port 443 protocol https
>>>     and request "/login"
>>>     with timeout 25 seconds
>>>     for 4 times within 5 cycles
>>>     then alert
>>> #port 443 protocol https
>>> #    if failed port 443 protocol https with ssl options {verify: disable} then alert
>>> 
>>> The resulting error message:
>>> 
>>> ~# service monit restart
>>>  * Restarting daemon monitor monit
>>>   /etc/monit/monitrc:338: Error: syntax error 'https'
>>> 
>>> So what could the problem be?  How can I check the https services?
>>> 
>>> thanks
>>> 
>>> Roland 
>>> 
>>> -- 
>>> To unsubscribe:
>>> https://lists.nongnu.org/mailman/listinfo/monit-general
>> 
>> -- 
>> To unsubscribe:
>> https://lists.nongnu.org/mailman/listinfo/monit-general
> -- 
> To unsubscribe:
> https://lists.nongnu.org/mailman/listinfo/monit-general

-- 
To unsubscribe:
https://lists.nongnu.org/mailman/listinfo/monit-general