Re: Cross-Compilation of NSS for MIPS platform fails.

On 18 March 2016 at 07:40, <[email protected]> wrote:

> Hi,
>    I went through the Firefox makefile and observed that I had set the
> flags which are listed there. So, I believe that might not be the problem.
> Yet, I shall build Firefox and see the build logs for better understanding
> as you had suggested.
> Initially, the libfreebl3.so was not building for MIPS platform, so I
> included a few lines of code to eliminate the following error :
> {standard input}: Assembler messages:
> {standard input}:79: Error: unrecognized opcode `bswap $2'
>
>

While there, hack the make file and add a printenv command.  From memory,
not all the make variables are passed explicitly, some get tunnelled via
the environment.



> Then libfreebl3.so got built and was being loaded.
>
>  The next issue which I faced at run time was in pkc11load.c .Here,
> C_Initialize() call returns CKR_CRYPTOKI_NOT_INITIALIZED due to which
> "CKR_GENERAL_ERROR" flag is being raised.
>   So, can you give any pointers on how I should debug further?
> --
> dev-tech-crypto mailing list
> [email protected]
> https://lists.mozilla.org/listinfo/dev-tech-crypto
>
-- 
dev-tech-crypto mailing list
[email protected]
https://lists.mozilla.org/listinfo/dev-tech-crypto