Re: TAKARA CAM MV137

Hi,

The camera is not known to us yet.

It seems to be an action cam, which likely might not allow remote control.

Is it exposed via USB storage?

Is there any software allowing remote control?

Can you post lsusb -v output for the camera?

Ciao, Marcus
On Sun, Mar 24, 2024 at 04:42:27PM +0000, Thibaut TURRIER wrote:
> Bonjour,
> =

> J'aimerais arriver =E0 faire fonctionner ma cam=E9ra TAKARA CAM MV137 sur=
 gphoto2.
> =

> Je suis sur RPI 3 Bullseye.
> =

> Voici les informations :
> =

>   *   Lsusb :
> Bus 001 Device 015: ID 1f3a:1002 Allwinner Technology mediacom XPRO 415
> =

>   *   gphoto2 --auto-detect :
> Model                          Port
> ----------------------------------------------------------
> =

>   *   LANG=3DC gphoto2 --summary >summary.txt
> *** Error ***
> Could not detect any camera
> *** Error (-105: 'Unknown model') ***
> =

>   *   LANG=3DC gphoto2 --list-all-config >config.txt
> *** Error ***
> Could not detect any camera
> *** Error ***
> An error occurred in the io-library ('Unknown error'): No error descripti=
on available
> *** Error (-105: 'Unknown model') ***
> =

>   *   gphoto2 --capture-image
> *** Error ***
> Could not detect any camera
> *** Error (-105: 'Unknown model') ***
> For debugging messages, please use the --debug option.
> Debugging messages may help finding a solution to your problem.
> If you intend to send any error or debug messages to the gphoto
> developer mailing list [email protected]<mailto:gphoto-d=
[email protected]>, please run
> gphoto2 as follows:
>     env LANG=3DC gphoto2 --debug --debug-logfile=3Dmy-logfile.txt --captu=
re-image
> Please make sure there is sufficient quoting around the arguments.
> =

> Je vous remercie,
> Cordialement,
> =

> Thibaut TURRIER
> [email protected]<mailto:[email protected]>
> =


> For debugging messages, please use the --debug option.
> Debugging messages may help finding a solution to your problem.
> If you intend to send any error or debug messages to the gphoto
> developer mailing list <[email protected]>, please run
> gphoto2 as follows:
> =

>     env LANG=3DC gphoto2 --debug --debug-logfile=3Dmy-logfile.txt --list-=
all-config
> =

> Please make sure there is sufficient quoting around the arguments.
> =


> For debugging messages, please use the --debug option.
> Debugging messages may help finding a solution to your problem.
> If you intend to send any error or debug messages to the gphoto
> developer mailing list <[email protected]>, please run
> gphoto2 as follows:
> =

>     env LANG=3DC gphoto2 --debug --debug-logfile=3Dmy-logfile.txt --summa=
ry
> =

> Please make sure there is sufficient quoting around the arguments.
> =



> _______________________________________________
> Gphoto-devel mailing list
> [email protected]
> https://lists.sourceforge.net/lists/listinfo/gphoto-devel