回复: 回复: About Olympus E-PL2

Thanks!


Best Regards,

Sam Huang

Product Designer | Waboba AB GZ Rep Office
Tele: +86-20-8890 2847
Room1606, Jinke Plaza, No. 19th GuangWei Road
YueXiu District, Guangzhou City, China  510030
Waboba.com<https://waboba.com/>
[cid:[email protected]]

发件人: Marcus Meissner<mailto:[email protected]>
发送时间: 2021年1月19日 14:41
收件人: Sam Huang<mailto:[email protected]>
抄送: [email protected]<mailto:[email protected]>
主题: Re: 回复: [gphoto-devel] About Olympus E-PL2

Hi,

You can only download the pictures you took with the camera manually.

You can not remotely trigger any capture or preview with this camera.

Ciao, Marcus
On Tue, Jan 19, 2021 at 06:31:47AM +0000, Sam Huang wrote:
> Thanks for your reply, Marcus. You mean try to using downloading of pictures to take the actual pictures? Sorry I am new to these, haha.
>
>
> Best Regards,
>
> Sam Huang
>
> Product Designer | Waboba AB GZ Rep Office
> Tele: +86-20-8890 2847
> Room1606, Jinke Plaza, No. 19th GuangWei Road
> YueXiu District, Guangzhou City, China  510030
> Waboba.com<https://waboba.com/>
> [cid:[email protected]]
>
> 发件人: Marcus Meissner<mailto:[email protected]>
> 发送时间: 2021年1月19日 14:27
> 收件人: Sam Huang<mailto:[email protected]>
> 抄送: [email protected]<mailto:[email protected]>
> 主题: Re: [gphoto-devel] About Olympus E-PL2
>
> On Mon, Jan 18, 2021 at 10:14:04PM +0000, Sam Huang wrote:
> > Hi,
> > I have an old camera Olympus E-PL2, I tried to use it for Gphoto on Octoprint, but it didn’t work, do you know how to make it work? It does show “MTP” when I plug in the USB into my pi.
> > It does detect the camera, but it shows the wrong model:
> > Olympus mju 500                usb:001,004
>
> The mju series does not support remote control, but only download of pictures.
>
> If downloading of pictures work, then we are ok.
>
> CIoa, Marcus
>

_______________________________________________
Gphoto-devel mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/gphoto-devel