Canon 1300D: can only capture one image; second capture fails

Hi,
 
I'm facing the issue that my new EOS 1300D cannot capture more then one image
with gphoto. The camera is detected and the first call to gphoto successfully
takes an image. If I request to capture an image again, the camera gets stuck
somehow and no shutter noise is done at all. If I push a button on the camera
directly, it shows busy on the display. If I switch the camera off and on again,
I can take one image again. But only one ;-)
 
AF is switched off, Sleep mode is deactivated.
ghoto&libgphoto were compiled manually. gphoto2 is the latest 2.5.11, libgphoto
is the latest 2.5.12, Ubuntu 12.10; kernel 3.5.0-31
I tested my installation successfully with my 5DMark3 and my 100D. My self
written program that directly calls libgphoto.so has the same issue.
 
 
I created 3 debug files:
 
This is the debug from the first capture with the successful image capture:
http://bit.ly/2kSxIu5
 
This is a debug from a second capture where the camera gets stuck somehow for a
long time until I send Ctrl+C. No image was taken, no shutter noise
http://bit.ly/2krEtCy
 
This is a debug from a second capture where the camera seems to run into a
timeout. No image was taken, no shutter noise
http://bit.ly/2jZox9J
 
 
Thank you very much and kind regards, Oliver

------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, SlashDot.org! http://sdm.link/slashdot

_______________________________________________
Gphoto-user mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/gphoto-user