Re: wait-event-and-download problem

Hi,

By default, the camera does "capture to SDRAM", where the
picture needs to be immediately downloaded and does not remain
on the SD Card.

This is probably the case here.

Can you check and adjust the "capturetarget" configuration variable
to be "card".

Ciao, Marcus
On Sat, Mar 25, 2017 at 12:07:14PM -0700, Giuseppe wrote:
> Hello,
> 
> I have a problem using gphoto2 with Canon EOS 1D Mark II and III.
> The camera uses two memory cards that operate in "separate recording".
> 
> The gphoto version is:
> gphoto2         2.5.11         gcc, popt(m), no exif, no cdk, no aa, no
> jpeg, no readline
> libgphoto2      2.5.12         all camlibs, gcc, ltdl, no EXIF
> libgphoto2_port 0.12.0         gcc, ltdl, USB, serial without locking
> 
> The gphoto run in debian 8.
> 
> If I use the command:
> gphoto2 --keep --wait-event-and-download
> 
> The photo is captured but not the copy remains in the camera memory.
> 
> Suggestions?
> 
> 
> thanks
> Giuseppe
> 
> P.S.
> Excuse me for my bad English
> 
> 
> 
> --
> View this message in context: http://gphoto-software.10949.n7.nabble.com/wait-event-and-download-problem-tp16634.html
> Sent from the gphoto-user mailing list archive at Nabble.com.
> 
> ------------------------------------------------------------------------------
> Check out the vibrant tech community on one of the world's most
> engaging tech sites, Slashdot.org! http://sdm.link/slashdot
> _______________________________________________
> Gphoto-user mailing list
> [email protected]
> https://lists.sourceforge.net/lists/listinfo/gphoto-user

------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot