bulb cannot work
XYang <[email protected]>
| Newsgroups | gmane.comp.multimedia.gphoto.user |
|---|---|
| Message-ID | <[email protected]> |
Hi, I'm new on gphoto2, and I'm trying to trigger a bulb capture on my Cannon EOS 100D camera. But when I try to set the shutter speed to bulb mode, an error happened: /*** Error *** The property 'Shutter Speed' / 0xd102 was not set, PTP errorcode 0x2019. *** Error *** Failed to set new configuration value bulb for configuration entry shutterspeed. *** Error (-110: 'I/O in progress') *** / Other commands work fine, I can capture photo correctly, and I can set other shutter speed, except bulb. And I tried to use /gphoto2 --config/ to set the shutter speed, still error: / Could not set configuration: I/O in progress/ I'm wondering what's going wrong with it? Is EOS 100D not suitable for bulb? -- View this message in context: http://gphoto-software.10949.n7.nabble.com/bulb-cannot-work-tp16650.html Sent from the gphoto-user mailing list archive at Nabble.com. ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot