Re: bulb cannot work
XYang <[email protected]>
| Newsgroups | gmane.comp.multimedia.gphoto.user |
|---|---|
| Message-ID | <[email protected]> |
Marcus Meissner-4 wrote > Hi, > > http://gphoto.org/doc/remote/ > > The howto was a bit wrong, but what works for me: > > Dial the camera to "M" mode. > > Then run: > gphoto2 --set-config shutterspeed=bulb > gphoto2 --set-config eosremoterelease=Immediate --wait-event=30s > --set-config eosremoterelease="Release Full" --wait-event-and-download=2s > > for a 30 second bulb exposure. > > Ciao, Marcus > > On Thu, Apr 06, 2017 at 06:42:28AM -0700, XYang wrote: >> Hi, >> >> I'm new on gphoto2, and I'm trying to trigger a bulb capture on my Cannon >> EOS 100D camera. But when I try to set the shutter speed to bulb mode, an >> error happened: >> >> /*** Error *** >> The property 'Shutter Speed' / 0xd102 was not set, PTP errorcode 0x2019. >> >> *** Error *** >> Failed to set new configuration value bulb for configuration entry >> shutterspeed. >> *** Error (-110: 'I/O in progress') *** >> / >> Other commands work fine, I can capture photo correctly, and I can set >> other >> shutter speed, except bulb. >> And I tried to use >> >> /gphoto2 --config/ >> >> to set the shutter speed, still error: >> / >> Could not set configuration: I/O in progress/ >> >> I'm wondering what's going wrong with it? Is EOS 100D not suitable for >> bulb? >> >> >> >> -- >> View this message in context: >> http://gphoto-software.10949.n7.nabble.com/bulb-cannot-work-tp16650.html >> Sent from the gphoto-user mailing list archive at Nabble.com. >> >> ------------------------------------------------------------------------------ >> Check out the vibrant tech community on one of the world's most >> engaging tech sites, Slashdot.org! http://sdm.link/slashdot >> _______________________________________________ >> Gphoto-user mailing list >> > [email protected] >> https://lists.sourceforge.net/lists/listinfo/gphoto-user > > ------------------------------------------------------------------------------ > Check out the vibrant tech community on one of the world's most > engaging tech sites, Slashdot.org! http://sdm.link/slashdot > _______________________________________________ > Gphoto-user mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/gphoto-user It is when run the code that the error happened: / gphoto2 --set-config shutterspeed=bulb / /Failed to set new configuration value bulb for configuration entry/ Is this because I didn't dial the mode to M？ -- View this message in context: http://gphoto-software.10949.n7.nabble.com/bulb-cannot-work-tp16650p16656.html Sent from the gphoto-user mailing list archive at Nabble.com. ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ Gphoto-user mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/gphoto-user