Re: gphoto2 with Sony ILCE-7M2 (a7 II)

Hi,

The implementation mirrors the behaviour of the Windows remote control which
has just up and down buttons.

The direct value property setting does not seem to work on those properties,
at least not on my Sony A58.

Ciao, Marcus
On Wed, Aug 30, 2017 at 11:29:17PM +0200, Jonas wrote:
> Hi users of gphoto2,
> for a series of pictures I need to alternate between two configurations, i.e. take one picture, change configuration, take next picture, change to other configuration.
> I have the commands for the two configurations:
> 
> 1st configuration:
> gphoto2 --set-config=/main/imgsettings/iso=1600 --set-config=/main/capturesettings/shutterspeed=50/10 --set-config=/main/capturesettings/f-number=16
> 
> 2nd configuration:
> gphoto2 --set-config=/main/imgsettings/iso=0 --set-config=/main/capturesettings/shutterspeed=1/40 --set-config=/main/capturesettings/f-number=1.8
> 
> The commands work but it needs quite a long time until they finish because the camera is walking through each single step from ISO 1600...0 (auto), then shutterspeed 50/10...1/40, then f-number 16...1.8.
> Each single step take ~0.5sek, so all steps together need >40sek to complete.
> 
> Is there a setting I can change to speed this up? (deactivate camera screen for example?)
> 
> Our Nikon D750 changes everything in one step within a second...
> 
> Thank you very much,
> Jonny
> 
> ------------------------------------------------------------------------------
> Check out the vibrant tech community on one of the world's most
> engaging tech sites, Slashdot.org! http://sdm.link/slashdot
> _______________________________________________
> Gphoto-user mailing list
> [email protected]
> https://lists.sourceforge.net/lists/listinfo/gphoto-user

------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot