mac support
Mark Burton <[email protected]> Mon, 17 Oct 2005 11:02:27 +0200
| Newsgroups | gmane.comp.multimedia.grip.user |
|---|---|
| Message-ID | <[email protected]> |
Hi, I've just downloaded and build grip for mac OS X (10.3) I found 2 problems, one the mailer (sendmail) didn't get set correctly, and two, the final link stage gives a LOT of warnings. However, the binary executes... The problem is that I can't work out which device to connect to. /dev/disk1 and /dev/rdisk1 both give "no disk" even though there is one... anything else seems to fail to initialise. Has anybody any experience in getting this to work on a mac? Cheers Mark. ------------------------------------------------------- This SF.Net email is sponsored by: Power Architecture Resource Center: Free content, downloads, discussions, and more. http://solutions.newsforge.com/ibmarch.tmpl