Re: (no subject)

The contents of my .buildrc is like this
AddMultiCVS("helix", "ext:[email protected]:/cvsroot/")
AddBIFPath("common", "[helix]/common/build/BIF")
AddBIFPath("client", "[helix]/client/build/BIF")

On Fri, Mar 20, 2009 at 6:06 PM, Jyotsana Rathore <[email protected]> wrote:
> Your .buildrc might be incomplete. Does it have these BIF Paths:
> AddBIFPath("common", "[helix]/common/build/BIF")
> AddBIFPath("client", "[helix]/client/build/BIF")
>
> Thanks,
> Jyotsana
>
> -----Original Message-----
> From: [email protected]
> [mailto:[email protected]] On Behalf Of vishwanath
> murthy
> Sent: Friday, March 20, 2009 1:40 PM
> To: [email protected]
> Subject: [Helix-client-dev] (no subject)
>
> Hi,
>
>  I am trying to build helix DNA client on Ubuntu
>  I dont get the full menu fro selecting the BIF branches
>  I dont know  whats is going wrong
>
> Build System Menu
> Ribosome v2.5.1
> -> Current Directory: /home/vishym/source/helix
> [0] Set BIF branch (helix)
> [1] Set Target(s) (splay_mp3)
> [2] Set Profile (default)
> [3] run: build
> [4] Toggle make depend & makefiles (-e -n)
> [5] Toggle release (-trelease)
> [6] Toggle 'make clean'  (-c)
> [7] Toggle clobber (Dangerous!) (-C)
> [8] Toggle halt-on-error (-p green)
> [9] Toggle verbose mode (-v)
> [10] Toggle static build (-tnodll)
> [11] Checkout source for selected target now
> [12] Set Tag/Branch/Timestamp
> [13] Help Page (full help in build/doc/index.html)
> [Q] Quit
> Enter selection or flags: 0
>
> [0] helix
> [1] helixproducer_11
> Select BIF (Q exits, ? for list): ?
>
> [0] helix
> [1] helixproducer_11
> Select BIF (Q exits, ? for list):
>
> _______________________________________________
> Helix-client-dev mailing list
> [email protected]
> http://lists.helixcommunity.org/mailman/listinfo/helix-client-dev
>
>