EBML specification component for review - About this Document

Erik Piil <[email protected]>
Newsgroups gmane.comp.multimedia.matroska.devel
Message-ID <CAKNa7H-7qKQXUqtFuffQ0OvrW7T+7uFPWYDEaJM2Q_3QifN+gQ@mail.gmail.com>
This discussion relates to the "About this Document" portion of the earlier
EBML RFC Draft for revision/incorporation into the final EBML
specification.

From the RFC Draft:

About this Document

This document is currently in its draft stage and is subject to changes.
The contents should not be relied upon for implementational purposes.

The key words "MUST", "MUST NOT", "REQUIRED", "SHALL", "SHALL NOT",
"SHOULD", "SHOULD NOT", "RECOMMENDED", "MAY", and "OPTIONAL" in this
document are to be interpreted as described in RFC 2119 [RFC2119].

The definitions in this document uses ABNF [ABNF]. Note that string
terminals are case insensitive in ABNF. The interpretation of binary values
has been slightly altered so that every bit must be explicitly printed,
e.g. %b0 is one zero bit while %b000 represents three zero bits. The
following (re)definitions are used throughout this document:

BIT = %b1 / %b0
BYTE = OCTET
WSP = SP / HTAB / CR / LF

Any thoughts are most appreciated.

Best,

Erik

_______________________________________________
Matroska-devel mailing list
[email protected]
http://lists.matroska.org/cgi-bin/mailman/listinfo/matroska-devel
Read Matroska-Devel on GMane: http://dir.gmane.org/gmane.comp.multimedia.matroska.devel
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.