Re: Clarification about [pd~]
Christof Ressi <[email protected]>
| Newsgroups | gmane.comp.multimedia.puredata.general |
|---|---|
| Message-ID | <[email protected]> |
In this case, just analyze the table piece-wise with a [metro]. The list method takes the following arguments: <table name> <number of points to analyze> <starting point> <sample rate> You can use <number of points> and <starting point> to analyze a particular section of a table. The help patch of [sigmund~] contains an example. Christof On 24.03.2025 14:37, Peter P. wrote: > * Christof Ressi <[email protected]> [2025-03-24 14:34]: > [...] >> Are you doing the FFT on the whole audio file at once? If you are doing >> large computations that interrupt audio processing, one key technique is to >> spread the computation over multiple scheduler ticks. > How would you go about to spread it over multiple ticks Christof? > > thanks! > P > > --- > [email protected] - the Pure Data mailinglist > https://lists.iem.at/hyperkitty/list/[email protected]/message/YCPSAOIGTIXVEWA2MBRFYMP5ZAH4V77P/ > > To unsubscribe send an email to [email protected] mailing list > UNSUBSCRIBE and account-management -> https://lists.iem.at/ > --- [email protected] - the Pure Data mailinglist https://lists.iem.at/hyperkitty/list/[email protected]/message/PL5X5Y7ERRPYFU2JFCCAJE5ML5YFKSW3/ To unsubscribe send an email to [email protected] mailing list UNSUBSCRIBE and account-management -> https://lists.iem.at/