Re: Comport Question

Note that Arduino is usually (or always?) connected through an USB device
which emulates a serial device (hence the comport).

In this case the baud rate has no meaning (the baud rate is only used by
physical UARTs).

Le jeu. 26 juin 2025 à 00:06, Antoine Rousseau <[email protected]> a
écrit :

> With the latest comport 1.3 (available on Deken) you can set the baud
> rate  up to 4000000, if your system allows it. See
> https://git.iem.at/pd/comport
>
> Le mer. 25 juin 2025 à 22:53, Alexandros Drymonitis <[email protected]> a
> écrit :
>
>> How did you find such a limitation? You can use it with a 115,200 baud
>> rate just fine on any OS (including Linux).
>>
>> On 6/25/25 23:50, Jim Ruxton wrote:
>> > I'm using the comport object to speak to an Arduino. I'm finding the
>> > fastest baud rate I could use was 19200.  I'm on Linux. Would anyone
>> > know if this is a limitation of the object in Linux or if there is
>> > something else going on. I'd like to send data faster if possible.
>> >
>> > ---
>> > [email protected] - the Pure Data mailinglist
>> >
>> https://lists.iem.at/hyperkitty/list/[email protected]/message/DHY4DX545CKEKBHN7OPOYUJHKWDTPRKI/
>> >
>> > To unsubscribe send an email to [email protected] mailing list
>> > UNSUBSCRIBE and account-management -> https://lists.iem.at/
>>
>> ---
>> [email protected] - the Pure Data mailinglist
>>
>> https://lists.iem.at/hyperkitty/list/[email protected]/message/Q6DX25FHMHUEOBX2LR36GWXRM57WEIQS/
>>
>> To unsubscribe send an email to [email protected] mailing list
>> UNSUBSCRIBE and account-management -> https://lists.iem.at/
>
>

---
[email protected] - the Pure Data mailinglist
https://lists.iem.at/hyperkitty/list/[email protected]/message/GSKHIVLO7GATSVJJJHDO6KWDBXNDWVFQ/

To unsubscribe send an email to [email protected] mailing list
UNSUBSCRIBE and account-management -> https://lists.iem.at/