Re: Pd-0.56-2 on IRIX (was Re: Re: [announce] pd 0.38-0test7 for IRIX)

You could try the distribution source tarball from Miller's site which will have the configure script generated or do it on a separate machine yourself (not on the SGI) then copy the result over via: make dist

> On Jan 14, 2026, at 12:56 AM, Wolfgang Gaggl <[email protected]> wrote:
> 
> Got the prerequisites installed on my SGI and downloaded your Pd-Irix branch. 
> 
> I'm getting stuck at the ./autogen.sh step, since I don't have autotools installed on my SGI. 
> I've looked at what's needed, and there are many dependencies that need to be met to install autotools. 
> 
> Since you mentioned that you had issues with autoreconf and did it on another machine, can you provide me with the the output file(s) so I can skip that step (would this allow me to skip the whole autogen.sh steps or only that autoreconf execution within autogen.sh)?
> 
> Thanks,
> Wolfgang
> ---
> [email protected] - the Pure Data mailinglist
> https://lists.iem.at/hyperkitty/list/[email protected]/message/6OZDP45OOVDG74QPKTUHMOMIONBIGZ5A/
> 
> To unsubscribe send an email to [email protected] mailing list
> UNSUBSCRIBE and account-management -> https://lists.iem.at/
> 

--------
Dan Wilcox
danomatika.com <http://danomatika.com/>
robotcowboy.com <http://robotcowboy.com/>

---
[email protected] - the Pure Data mailinglist
https://lists.iem.at/hyperkitty/list/[email protected]/message/IJW5JXVUI32UYPVGFXA37UFP2Q52MOQ5/

To unsubscribe send an email to [email protected] mailing list
UNSUBSCRIBE and account-management -> https://lists.iem.at/