Re: build.pl debug=1 for sw and svx
Niklas Nebel <[email protected]>
| Newsgroups | gmane.comp.openoffice.devel.general |
|---|---|
| Message-ID | <[email protected]> |
On 06.04.2011 08:54, tora - Takamichi Akiyama wrote:
> Could you tell me how to easily do "build.pl debug=1" or similar
> actions in a specific, renovated module such as sw and svx after
> fully building the entire source code tree with normal options?
>
> The way I used to do was like this:
>
> (full build)
> cd $SRC_ROOT
> dmake
>
> (individual build with a debug option)
> cd sw
> mv $INPATH ${INPATH}-normal
> build.pl debug=1
>
> An attempt like that seems no longer applicable with the recent
> DEV300_m10x.
> It seems files being created are now stored in solver/, instead.
> It is cool and makes me excited. :-)
To rebuild a single module with debug info in the new build system, use
cd sw
make -sr clean
make -sr debug=t
See also http://blogs.sun.com/GullFOSS/entry/gbuild_meet_the_new_boss.
Niklas
--
-----------------------------------------------------------------
To unsubscribe send email to [email protected]
For additional commands send email to [email protected]
with Subject: help