Re: build.pl debug=1 for sw and svx

On 06.04.2011 18:45, tora - Takamichi Akiyama wrote:
> make -r deliverlog running on OpenSolaris x86 prints same type of
> warning messages and then eventually create the log file.
>
> $ make -r deliverlog
> ...
> make: *** Warning: .LOW_RESOLUTION_TIME file
> `/xxxxx/solver/300/unxsoli4/inc/svx/sxsoitm.hxx' has a high resolution
> time stamp
> ...(repeated 2 by 500 times for each file)...
>
> On OpenSolaris x86, even after executing "make -sr && make -r
> deliverlog," the "delivered" file under $OUTDIR is slightly older (in
> nanoseconds) than its original one. Consequently, copy action might
> occur again and again. Should I use /usr/gnu/bin/cp instead of /bin/cp,
> or else???

Is it really copied again? The whole point of .LOW_RESOLUTION_TIME is to 
ignore these small differences (see 
http://www.gnu.org/software/make/manual/html_node/Special-Targets.html 
and 
http://wiki.services.openoffice.org/wiki/Build_Environment_Effort/Status_And_Next_Steps).

Niklas
--
-----------------------------------------------------------------
To unsubscribe send email to [email protected]
For additional commands send email to [email protected]
with Subject: help