Need help with building DEV300m106 with cygwin

Hi,

I need help with building DEV300m106. I use cygwin and MSVC 2008 Express 
on WinXP. I have got a build in the end, but the program has no menus 
and no toolbars and therefore cannot be used. So something went entirely 
wrong. What can cause this?

I have got the source from http://hg.services.openoffice.org/DEV300/
I have applied the patch from 
http://openoffice.org/bugzilla/show_bug.cgi?id=117793
I have set --enable-cairo in my config settings.
I have build and delivered cairo manually.

My last successful build was DEV300m100. But DEV300m106 does not build 
with the configure settings I used for DEV300m100. It fails in pango 
because of missing cairo.h.

Kind regards
Regina


-- 
-----------------------------------------------------------------
To unsubscribe send email to [email protected]
For additional commands send email to [email protected]
with Subject: help