Re: Need help with building DEV300m106 with cygwin

Hi Mathias,

with copying the missing config files the build works so far, that I can 
use it to debug in sc.

Mathias Bauer schrieb:
> On 16.05.2011 12:15, Regina Henschel wrote:
>> Hi Mathias,
>>
>> Mathias Bauer schrieb:
>>> On 16.05.2011 11:10, Regina Henschel wrote:

>>>> I have got the source from http://hg.services.openoffice.org/DEV300/
>>>> I have applied the patch from
>>>> http://openoffice.org/bugzilla/show_bug.cgi?id=117793
>>>> I have set --enable-cairo in my config settings.
>>>> I have build and delivered cairo manually.
>>>
>>> Does that mean that you don't have these problems if you build without
>>> --enable-cairo?
>>
>> Without --enable-cairo setting or with setting --disable-cairo it
>> doesn't build at all, because pango is missing cairo.h. If I then try to
>> build cairo manually, it says that it is not enabled.
>
> I can not confirm this problem. I had no problem with building OOo
> DEV300_m106 on Windows/cygwin without specifying any cairo related
> switches.

I do a build with switch --enable-dbgutil, does it make a difference?

There had been at lot of stops and resuming, that I think it is best, if 
I start from scratch again, and then report each single problem 
immediately. Perhaps then it is easier to see, what goes wrong in my 
environment. Shall I start without any cairo related switches?

Kind regards
Regina
-- 
-----------------------------------------------------------------
To unsubscribe send email to [email protected]
For additional commands send email to [email protected]
with Subject: help