Re: Build DEV300_m106 on Linux breaks in module vcl

Hi Simon,

Simon Wilper schrieb:
> Hi everyone,
>
> I was trying to build a DEV300_m106 on Linux lately and got the
> following make error when it comes to build vcl:
>
> R=/home/sxw/work&&  S=$R/DEV300&&  O=$S/solver/300/unxlngi6.pro&&  W=$O/workdir&&   mkdir -p $O/lib/&&  /bin/cp --remove-destination --force --preserve=timestamps  $O/lib/libicule.so
> /bin/cp: missing destination file operand after `/home/sxw/work/DEV300/solver/300/unxlngi6.pro/lib/libicule.so'
> Try `/bin/cp --help' for more information.
> make: *** [/home/sxw/work/DEV300/solver/300/unxlngi6.pro/lib/libicule.so] Error 1
>
> I found out that the cp command is issued in solenv/gbuild/Deliver.mk and one
> of the two variables $(1) is empty.  Unfortunately I don't know
> make that good to debug this issue any further.
>
> Maybe one of you can shed some light on this?

Please read the last paragraph from Mathias Bauer in 
http://openoffice.org/projects/www/lists/dev/archive/2011-05/message/41

Kind regards
Regina
-- 
-----------------------------------------------------------------
To unsubscribe send email to [email protected]
For additional commands send email to [email protected]
with Subject: help