Re: issue 116457 - datapilot fails if cellrange contains empty field name

Hi,

the behavior to make changed source data to only show up after refresh 
has in general been done by intention. See Issue 55266 which has been 
addressed in 3.3 release 
(http://www.openoffice.org/issues/show_bug.cgi?id=55266 and also in the 
Wiki at 
http://wiki.services.openoffice.org/wiki/Calc/Proposal_DataPilot_byIBM)

But of course it looks like some additional improvement is required, eg 
if a new data area is selected in the dialog, the current behavior might 
need to be changed again as Niklas Nebel already told me.

This is an important change for the next release. But from my point of 
view this is nothing which should prevent us from releasing 3.3rc10 as 
it is now.

Martin D.

Am 20.01.11 18:08, schrieb Oliver Brinzing:
> Hi
>
>> Am 17.01.2011 10:05 schrieb Martin Damboldt:
>> To be honest, this issue doesn't sound critical enough to delay the 3.3 release any further. We
>> should address this in the next release instead from my point of view.
>
> ok, but now there is a another datapilot (regression) issue:
>
> Datapilot do not update after changes in selection from field
> http://www.openoffice.org/issues/show_bug.cgi?id=116504
>
> and a duplicate of my issue 116457:
>
> No column headers appears in Datapilot dialog if any of column cells is empty
> http://www.openoffice.org/issues/show_bug.cgi?id=116505
>
>> The issue is rather irritating because quite often
>> hidden columns might not have header.
>
> so maybe someone can have a closer look ;-)
>
> Regards
>
> Oliver