Re: Domain name parser not working
Joel de Guzman <[email protected]>
| Newsgroups | gmane.comp.parsers.spirit.general |
|---|---|
| Message-ID | <[email protected]> |
On 03/01/2018 6:59 AM, Michael Powell wrote: > On Tue, Jan 2, 2018 at 3:24 PM, Joel de Guzman<[email protected]> wrote: >> On 02/01/2018 11:42 PM, Michael Powell wrote: >>> Now after providing additional follow up, live examples, etc, any >>> feedback on this at all? >>> >>> This cannot be that difficult, however any of the documentation, etc, >>> I am scanning does not seem to work or are incomplete at best, which >>> isn't helping the case. >> >> Not sure. I know you presented some code, but is it minimal enough? >> To me, minimal code would look like something like the code here: >> http://boost-spirit.com/home/feedback-and-support/ > There is nothing I consider extraneous in the examples I presented. > There is a test scaffold, the grammar, and the AST. It's all pretty > clearly outlined in the examples. Anything more or other than that I > would consider NOT minimal. Give it some more effort. For example, focus on one exact problem. The very subject of this thread does not even convey any usable information other than "not working". Most often than not, I could distill problematic code to only a few lines --one or two rules is ideal. You do not even have to have grammars. Also, get rid of the scaffolding, etc. Again, you'll have better luck if the essence of your question can be fully comprehended in one or two minutes. Do I need to study RFC 1034 to understand your problem? If not, then that information is extraneous. If yes, then your issue requires too much investment in time (at least for me). Regards, -- Joel de Guzman http://www.ciere.com http://boost-spirit.com http://www.cycfi.com/ ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot