Re: windows 2008 R2, Apache 2.2, Php 5.3.4, phpinfo () renders as a white page

he is asking about apache 2.2....

On Fri, Dec 10, 2010 at 2:52 PM, Tommy Pham <[email protected]> wrote:
>> -----Original Message-----
>> From: G?ran Eriksson [mailto:[email protected]]
>> Sent: Friday, December 10, 2010 5:05 AM
>> To: [email protected]
>> Subject: [PHP-WIN] windows 2008 R2, Apache 2.2, Php 5.3.4, phpinfo ()
>> renders as a white page
>>
>> I have installed a clean windows 2008 R2, 2nic, No IIS.
>> Installed Apache 2.2, (msi format), added the page index.php with <?
>> phpinfo(); ?> it renders as a text page (ok).
>> First try before that was with 1nic and co-op with IIS, using 2ipaddresses
>> though (didnt work either).
>> Then I installed php 5.3.4 (msi format) VC6 thread safe, apache 2.2.x
>> module, it automatically updates hhtpd.conf with; #BEGIN PHP INSTALLER
>> EDITS - REMOVE ONLY ON UNINSTALL PHPIniDir "C:/PHP/"
>> LoadModule php5_module "C:/PHP/php5apache2_2.dll"
>> #END PHP INSTALLER EDITS - REMOVE ONLY ON UNINSTALL Now the page
>> renders just as a white page.
>>
>> Renames php.ini to pphp.ini, restarts apache, now I can see the phpinfo()
>> ok.
>> (the idea was from others who had a white page) Changed php to php
>> 5.2.15, same error.
>> Seen that Ipv6 can be a problem, unbinded that from nic, same error.
>> Is there anyone who tested my config and got it to work?
>>
>> Brgs Göran Eriksson
>>
>
> I'm unable to understand your situation.  I'm running both IIS and my own 64
> bit compilation of Apache httpd fine on Win08r2 with both NICs, one is
> integrated the other is add-on wireless.  What is your intention?  Have each
> webserver on separate NIC?  If so, are you sure that you configured each
> correctly?  If both on the same NIC, port conflict?  Look at the error logs
> for Apache and in the Windows event viewer for IIS.  NOTE:  you must use PHP
> VC6 binaries if you're using Apache's binary distribution and PHP as module
> as it mentions in the download page.  As for IIS, did you get the NTS build
> to run as FastCGI?  Only problem you should have concerning IPv6 on Windows
> is relating to MySQL resolving host name, IIRC, which you'll have to use
> IPv4 address instead.
>
> Regards,
> Tommy
>
>
> --
> PHP Windows Mailing List (http://www.php.net/)
> To unsubscribe, visit: http://www.php.net/unsub.php
>
>



-- 
Pierre

@pierrejoye | http://blog.thepimp.net | http://www.libgd.org

-- 
PHP Windows Mailing List (http://www.php.net/)
To unsubscribe, visit: http://www.php.net/unsub.php