Options fitplot and fit-to-page.
"G.W. Haywood" <[email protected]>
| Newsgroups | gmane.comp.printing.cups.bugs |
|---|---|
| Message-ID | <[email protected]> |
Hi there, I've been tearing out what little hair I have left trying to scale PDF files to A4 using command line options to lp. The files are mostly engineering drawings which were originally created for A2 sheets. The man page for lp talks about the fitplot option. It's listed under "COMMON JOB OPTIONS". It didn't seem to do anything at all. Grepping the CUPS source I see not only that fitplot has been deprecated, but also that it appears specifically to apply only to HP-GL/2 plot files. This is not mentioned in the man pages. The scaling option doesn't work here either, using both "scaling=10" and "scaling=30" produces a plot of about 2 inches by 3 inches from the A2 PDF drawings, centred in the A4 page. Finally I stumbled across the fit-to-page option which worked at last but doesn't seem to be mentioned anywhere in the man pages. Can I send you a patch for the man pages, and if so where and how? -- 73, Ged.