Re: [cups-devel] Question: Adding group 'wheel' to CUPS system groups by default

There are a variety of historical reasons this is the case, but ultimately this is a) configurable and b) defaults to whatever the Linux distribution wants.

> On Dec 20, 2016, at 10:43 AM, Zdenek Dohnal <[email protected]> wrote:
> 
> On 12/20/2016 04:04 PM, Helge Blischke wrote:
>>> Am 20.12.2016 um 12:42 schrieb Zdenek Dohnal <[email protected]>:
>>> 
>>> Hi,
>>> 
>>> I have question about CUPS system groups. Is it possible to add group
>>> 'wheel' to default CUPS system groups in configure? If it is not, can
>>> you please someone explains why not?
>>> 
>>> Thank you for answer in advance.
>>> 
>>> Best regards,
>>> 
>>> Zdenek Dohnal
>> By default, wheel is not a member of the CUPS system groups. But you may explicitly
>> define which groups belong to the system groups by using the 
>> SystemGroup
>> directive in cups-files.conf.
>> 
>> Helge
>> 
>> _______________________________________________
>> cups-devel mailing list
>> [email protected]
>> https://lists.cups.org/mailman/listinfo/cups-devel
> Yes, I know group 'wheel' is not a member of the CUPS default system
> groups, but my question was why it is not. And if it can be added as
> default CUPS system group at configuration time (not manually define in
> cups-files.conf after installation). Probably I did not express myself
> clearly, I am sorry.
> 
> 
> _______________________________________________
> cups-devel mailing list
> [email protected]
> https://lists.cups.org/mailman/listinfo/cups-devel

_________________________________________________________
Michael Sweet, Senior Printing System Engineer